Siemens SCALANCE W788-1PRO Operating Instructions Manual page 200

Configuration Using Web Based Management and the Command Line Interface
If you enter a zer
calculated autom
Admin Edge Port
Enable this check box if an end device is connected to this port, otherw
reconfiguration of the network will be triggered by every link change.
Admin Point to Point Status check boxes
Here, there are three possible settings:
Shared media Connectio
This corresponds to the ent
Point to Point Connection is selected:
This corresponds to the entry ForceTrue in the port table.
Point to Point Connection and Shared Media Connection are not
selected:
This
Note
Point-to-point means a direct connection between two stations. A shared media
connection would, for example, be a connection from the Ethernet port to a hub or
a WDS connection between two a
Syntax of the Command Line Interface
C LI\BRIDGE\S PANNING\PORT
Command
info
portstp <E|D> [ports]
portprio <Port>
[0 ... 255]
stp_cost <Port>
[1 ... 65535]
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
o for the RSTP value, the value for the path costs is
atically.
check box
n is selected:
corresponds to the entry Auto in the port table.
S>
Displays the current Spanning Tree
configuration for all ports.
Enables / di
algorithm for the specified ports.
Specifies the priority of the port.
Specifies the path costs for the port
if Version is set to STP.
ry ForceFalse in the port table.
ccess points.
Description
sables the spanning tree
ise a
Comment
Default value: 128
Default value: 100
200