Siemens SCALANCE W788-1PRO Operating Instructions Manual page 201

Configuration Using Web Based Management and the Command Line Interface
Command
rstp_cost <Port>
[0 ... 200000000]
edgeport <Port> [T|F]
ptpport <po rt> <A|T|F>
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
Des cription
Specifies the path costs for the port
if Version is set to RSTP. If the value
is 0, the value is calculated.
Specifies whether or not an edge
port (T) or a station (F) that supports
spanning tree or rapid spanning tree
is attached to this port. if a (rapid)
spanning tree protocol is received,
the value F is displayed
automatically.
The point-to-point link establishes a
direct link between two stations. In
this case, you have the following
options:
A The p ort recognizes a PtP port
based on the duplexity. In full
duplex, a PtP link is assumed,
in half duplex no PtP link is
assum ed (shared me
T Specifies a PtP link, even
though half duplex is being
used.
F Specifies that there is no PtP
link over the relevant port ev
with full duplex.
Comment
Default value: 0
dium).
en
201