Siemens SCALANCE W788-1PRO Operating Instructions Manual page 236

Configuration Using Web Based Management and the Command Line Interface
Overlap AP
Note
This menu
For optimum data throu
used by other access p
overlapping of the wire
set channel but also the
make sure that there is
The Overlap AP page s
adjacent channels (at 2.4 GHz). If entries exist here, the maximum data throu
of the a ccess point will
Type
Shows the type of conn
exist.
MAC address
The MAC address of the
Channel
The channel on which t
Signal
S hows the signal strength with which the other wireless devices are received at the
AP. The stronger the signal, the greater the probability that they interfere with each
other. There is also the possibility that they interfere with each other even at low
signal strengths.
Age
Shows when the last activity was detected by the wireless device.
SSID
Shows the SSID of the other wireless device.
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
command is available o
ghput, it is important that the set w
oints. In the 2.4 GHz band (802.11
less channels so that an acces
two or three adjacent channels. Y
adequate channel spacing to neigh
hows all access points that are vi ble on the set or
be restricted.
ection. The types AP (infrastructure mod
wireless devices.
he found wireless device tran
nly in the ac cess point mode.
s point occupies not only the
si
smits.
ireless channel is not
b or 802.11g), the re is
ou should therefore
boring access points.
ghput
e) and AdHoc
236