Configuration Using Web Based Management and the Command Line Interface
Note
In WDS mode, the follo
●
All SCAL
the same channel.
●
You can only use the e
●
If you want to attach a di
WDS, you must configure
parameter does not work
●
In the IEEE 802.11h tran
mode at the same time. I
use the same channel. If
th
e channel is changed a
terminated.
To enable the entry, you mus
Syntax of the Command Line Interfa
CLI\BRIDGE\WDS\WLAN1>
or for the second wireless adapter (if it exists)
CLI\BRIDGE\WDS\WLAN2>
Command
a
dd <MAC|Name>
[SE|SD][Key]
edit <index> [E|D]
[SE|SD] [Key]
delete <Index>
clearall
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
wing restrictions apply:
ANCE W78x devices that will comm
nc
ryption schemes W
fferent access point from the SC
the MAC address. Detection using the sy
in this situation.
smission mod
n WDS mode, all SCALANCE W78x devices must
a signal from a primary us
utomatically and the existing connection is the
t select the Sel
ce
Description
Adds a
new WDS connection. Enter
either a
MAC address or a
sysNam
e. With the SE or SD
param
eters, you can enable or
disable
encrypti
enable
d, the key must also be
specifi
ed.
Changes the WDS connection
specified by Index. With [E|D], you
can enable / disable the connection.
Deletes the connection with the
specified index.
Deletes all WDS connections.
unicate with
EP and AES.
e, it is not practical to select the WDS
er is detected by an AP,
check box.
on. If encryption is
each other must use
ALANCE W78x over
sName
n
Comme
nt
182