Siemens SCALANCE W788-1PRO Operating Instructions Manual page 108

Configuration Using Web Based Management and the Command Line Interface
6. During the restart, the acce
7. The access point loads the current HiPath firmware for the W788 from the
HiPath Wi
The HiPath firmwa
due to reconfiguring with the HiPath Wireless Controller.
The HiPath firmware for the SCALANCE W788 has the following name
W788-<Version>.img,
where <Version> stands for the current version number.
Note
After sta rting up with the HiPath firmware, the access point can no longer be found
with the PST.
Note
Operating SCALANCE W client mo
HiPath access point or SCALANCE W access point in HiPath Access Point mode
involves the following
• The IP configuration of the WLAN client module (WBM page System > IP
Settings) must not be set on to DHCP server. It may be necessary to reserve
a range of IP addresses for the fixed IP settings of the WLAN client modu
• The MAC Mode parameter on the WBM page Interfaces > WLAN must not be
set to Adopt own MAC (see Section 6.3.2, WLAN).
• The WBM and Telnet of the WLAN c
Ethernet.
After loading the HiPath firmware, the R1 and R2 LEDs indicate the enabled
antenna ports:
● R1 lit
The upper antenna connectors A1 and B1 are enabled (transmission standard
IEEE 802.11a).
● R2 lit
The lower antenna connectors A2 and B2 are enabled (transmission standard
IEEE 802.11b/g).
Note
In HiPath Access Point mode, the LEDs of the SCALANCE W788 have a different
significance compared with that in the Access Point or Client mode.
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
ss point connects to the HiPath Wireless Controller.
reless Controller and runs a restart.
re is retained in the RAM of the AP when there is a restart
dules (W74x or W788 in client mode) on a
restrictions:
lient module can only be reached over
les.
108