Siemens SCALANCE W788-1PRO Operating Instructions Manual page 198

Configuration Using Web Based Management and the Command Line Interface
Note
If clien ts with the layer 2 tunneling function enabled connect to the access point, a
separate port is opened for each of these clients. These ports can
configured for Rapid Spanning Tree. The settings (for example, pr
co ts etc.) of the cell over which the c s
adopted.
Example: An L2T client is connected to the access point over the WLAN1 VAP3
(Wireless 1_3) interface. The settings for WL
costs for STP of 100, path costs for RSTP of
(in other words, there is an end device on this port). These settings are adopted for
the L2T port with one exception.
The Edge-Port enabled setting is no
and the ports downstream from the client can never be edge ports.
P.t.P.
There is a point-to-point link when two RSTP-compliant network components
are c
ForceTrue
Even with half duplex, a direct link is assumed.
ForceFalse
Despite a full duplex connection, a point-to-point link is not assumed.
Auto
Point-to-point is detected automatically. If the port is set to half duplex
(shared media connection), a direct link is not assume
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
onnected together over this port. There are three possible statuses :
lient is connected to the access point are
AN1 VAP3 are: priority 128, path
0 and the setting EdgePort enabled
t adopted because layer 2 tunneling clients
not, however, be
iority and path
d.
198