Siemens SCALANCE W788-1PRO Operating Instructions Manual page 241

Configuration Using Web Based Management and the Command Line Interface
Enabled
Indicates
further frames are forwarded over this port.
Cost
Indicates the path
Priority
Indicates the current priority of the port.
Edge
Shows whether or not the port is an edge port.
P.t.P.
Shows whether or not the AP is connected directly to ano
Port State
With STP, a port can adopt three states:
● Discarding
No frames are forwarded from or to this port. The port has been disable by the
user or the protocol (for example, when a redunda
● Learning
The port receives packets in the same way as in list
forward them. T
● Forwarding
The port is fully e
● Disabled
The port is not currently in use.
State
Here, the state
state means that the port is connected directly with the root bridge. DESIGNATE
identifies all ports that are not directly at the root but that are enabled. P
are blocked are in the BL
Syntax of t he Command Line Interface
The Command Line Interface contains the information on the Spanning Tree
protocol in CLI\INFORM\S
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
whether the (R)STP is enabled for this port. If the port is not enabled, no
costs for the port.
he MAC addresses are also entered in the Learning Bridge.
nabled. Frames can be received and sent.
of the port in relation to the root bridge is displayed. The
OCKED state.
panning.
ther (R)STP device
nt path has been detected).
ening mode, but does not
ROOT
orts that
D
241