Configuration Using Web Based Management and the Command Line Interface
Syntax of the Command Line Interfac
CLI\INTERFACES\WLAN1\ADVANCED>
Co
mmand
power [0...4
]
beacon [20 ... 1000]
dtim [1 ... 255]
rtsthr [1 ... 2346]
fragthr [256
... 2346]
bkscan [D|I|A]
bkscanint [200...60000]
bkchannel [channels]
bkchsel [E|D]
force [E|D]
roamthr
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
e
Description
Specifies by how many dB the
transmit power will be reduced
compared with full power:
0
Full power
1
-3 dB, half
2
-6 dB, quarter
3
-9 dB, eighth
4
Minimum power, -12 dB
Specifies the beacon interval in
milliseconds.
Specifies the data beacon rate.
Specifies the packet size as of which
RTS/CTS is used.
Specifies the s
ize as of which
packets are fragmented.
Specifies the mode in which the
client scans for further access
points.
D
Disabled
I
Scan if idle
A
Scan always
Interval at which the client scans for
further access points.
Selection of channels on which the
client scans
for further access
points.
The channels are entered separated
by bl
anks.
Enables / disables sca
nning for
further access points
to specific
chan
nels.
Enables / disables roaming if the
connection is lost on Ethernet
interface.
Decides the threshold at which the
client changes to another AP.
low
changes at a
slightly higher
field strength to the AP
with the stronger signal.
medium
changes at a
moderately higher field strength
to the AP with the
stronger
signal.
high
changes at a
significantly higher field strength
to the AP with the
stronger
signal.
Comment
Available only in the
access point mode.
Available only in the client
mode.
Available only in the client
mode.
Available only in the client
mode.
Available only in the client
mode.
Available only in the
access
point mode.
154