Siemens SCALANCE W788-1PRO Operating Instructions Manual page 109

Configuration Using Web Based Management and the Command Line Interface
Note
In HiPath Access Point mode, the following restrictions apply
• No use of the C
• No WDS
•
No iPCF possible.
• Heavy data traffic in
quality of the individ
This means that a re
The following table sho
AP2600 and the SCAL
HiPath AP2600
LED
5 GHz
2.4 GHz
Middle
Middle
For the arrangement of the LEDs on the device, refer to Figure 2-1 "The LEDs of
the SCALANCE W78x".
For information on the other steps in configuration, refer to the manual HiPath
Wireless Controller, Access Points and Convergence Software - User Guide.
Exiting the HiPath Mode
If you want to return the Scalance W access point to the standard modes "Access
Point" or "Client Mode", the HiPath firmware must be deleted in RAM. To do this,
turn of the power to the Scalance W AP for at least 30 seconds. Following this, the
AP starts up again with the SCALANCE W firmware and it is now possible to
change the mode over the Web interface.
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
-PLUG possible
and no redundancy p ossible.
the cell (for example, resultin
ual wireless connections (
sponse time cannot be defin
ws the significance of the LEDs of
ANCE W788-2
Color
- - -
- - -
(power supply Eth
Green
Green
Yellow
- - -
Red
g from voice) can impair the
for example, S7 communication).
ed.
the HiPath access point
RR in the HiPath Access Point mode:
SC ALANCE W788-2RR in
HiP ath Access Po
LED
(meaning)
P1
(Ethernet port)
L2
ernet)
R1
R2
R1 + R2
L1
(power supply M12)
F
(fault)
int mode
Color
Yellow/green
Green
Green
Green
Yellow
Green
Red
109