Configuring The Network Access Devices Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

80 Chapter 3 Managing the network access devices
The
SNAS 4050 cluster.

Configuring the network access devices using the CLI

When you first add a network access device to the Nortel SNAS 4050 domain, the
switch is disabled by default. Do not enable the switch until you have completed
configuring it. In particular, do not enable the switch until you have mapped the
VLANs (see
necessary SSH keys (see
If you want to reconfigure the VLAN mappings or delete a VLAN for an existing
network access device, use the
disable the switch first.
To configure a network access device in the Nortel SNAS 4050 domain, use the
following command:
/cfg/domain #/switch <switch ID>
where
The Switch menu displays.
320818-A
command removes the current switch from the control of the Nortel
delete
"Mapping the VLANs using the CLI" on page
Note: Remember to enable the network access device after completing
the configuration in order to activate the network access device in the
Nortel SNA network.
is the ID or name of the switch you want to configure.
switch ID
"Managing SSH keys using the CLI" on page
/cfg/domain #/switch #/dis
82) and exchanged the
84).
command to