Removing A Host Interface; Configuring Static Routes Using The Srem - Nortel Secure Network Access Switch 4050 User Manual

514 Chapter 10 Configuring system settings

Removing a host interface

To delete a host interface, perform the following steps:
1
2
3
4
5

Configuring static routes using the SREM

Static routes can be applied to a cluster, a host, or a particular interface. To view or
configure static routes at a particular level, choose from the following sections:
•
•
•
All static route are configured the same way, as described in
routes" on page
320818-A
Select the System > Hosts > host > Interfaces tab.
The Interfaces screen appears (see
Select an interface from the list.
Click Delete.
A confirmation dialog appears.
Click Yes.
The interface is removed from the Interfaces list.
Click Apply on the toolbar to send the current changes to the Nortel
SNAS 4050. Click Commit on the toolbar to save the changes permanently.
"Viewing static routes for a cluster" on page 515
"Viewing static routes for a host" on page 516
"Viewing static routes for an interface" on page 517
517.
Figure 133 on page 508).
"Managing static