Configuring Domain Parameters Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

130 Chapter 4 Configuring the domain

Configuring domain parameters using the CLI

To configure the domain, use the following command:
/cfg/domain <domain ID>
where
domain in the Nortel SNAS 4050 cluster.
The Domain menu displays.
The Domain menu includes the following options:
/cfg/domain <domain ID>
followed by:
name <name>
pvips <IPaddr>
aaa
server
320818-A
is an integer in the range 1 to 256 that uniquely identifies the
domain ID
Names or renames the domain.
• is a string that must be unique in the domain.
name
The maximum length of the string is 255
characters.
The name is a mnemonic aid only and is not used by
other functions.
Sets the pVIP for the domain. The pVIP is the portal
address to which clients connect in order to access the
Nortel SNA network. For more information, see
the IP addresses" on page
A domain can have more than one pVIP. To configure
multiple IP addresses for the portal, use a comma to
separate the IP address entries.
Accesses the AAA menu, in order to configure
authentication, authorization, and accounting features.
• For authentication, see
on page 233.
• For authorization, see
profiles" on page 191
TunnelGuard check using the CLI" on page
• For accounting, see
accounting using the CLI" on page
Accesses the Server menu, in order to configure the
portal SSL server (see
using the CLI" on page
51.
"Configuring authentication"
"Configuring groups and
and "Configuring the
"Configuring RADIUS
146.
"Configuring the SSL server
135).
"About
132.