Configuring Srs Control Settings Using The Srem - Nortel Secure Network Access Switch 4050 User Manual

Configuring SRS control settings using the SREM

To create and modify the TunnelGuard Software Requirement Set (SRS) rules,
you must use the SREM (see
you can access the Rule Builder utility in the SREM, you must enable support for
SRS administration.
To configure support for managing the SRS rules, perform the following steps:
1
Figure 156
SRS Control Settings
Select the System > Administrative > SRS Control Settings tab.
The SRS Control Settings screen appears (see
Chapter 10 Configuring system settings 547
"TunnelGuard SRS Builder" on page
Nortel Secure Network Access Switch 4050 User Guide
317). Before
Figure 156).