To restart communication between the Nortel SNAS 4050 and a network access
device, use the following command:
/cfg/domain #/switch #/ena
Enter
Managing network access devices using the SREM
The Nortel SNAS 4050 starts communicating with the network access device as
soon as you enable the switch on the Nortel SNAS 4050.
You cannot configure the VLAN mappings for a network access device in the
Nortel SNAS 4050 domain if the switch is enabled. When you add a network
access device to the domain, it is disabled by default. Do not enable the network
access device until you have completed the configuration. For information about
enabling and disabling the network access device, see
communication with the network access devices using the SREM" on page
Adding a network access device using the SREM
To add a network access device, use the following steps:
1
to apply the change immediately.
apply
Note: Remember to enable the network access device after completing
the configuration, or it will not be active.
Select the Secure Access Domain > domain > Switches > Switches tab.
Chapter 3 Managing the network access devices 91
Nortel Secure Network Access Switch 4050 User Guide
"Controlling
115.