Deleting A Network Access Device Using The Srem; Configuring The Network Access Devices Using The Srem - Nortel Secure Network Access Switch 4050 User Manual

4
Click Apply.
The network access device appears in the list of Switches.
5
Click Commit on the toolbar to save the changes permanently.

Deleting a network access device using the SREM

To remove an existing network access device from the domain configuration, you
must first disable it (see
page 91). Once the network access device is disabled, complete the following
steps:
1
Select the Secure Access Domain > domain > Switches > switch >
Configuration tab.
The network access device Configuration screen appears (see
page 116).
2
Select the network access device from the Switches list.
3
Click Delete.
A dialog box appears to confirm that you want to delete this network access
device.
4 Click Yes.
The network access device disappears from the Switches list.
5 Click Commit on the toolbar to save the changes permanently.

Configuring the network access devices using the SREM

When you first add a network access device to the Nortel SNAS 4050 domain, the
switch is disabled by default. Do not enable the switch until you have completed
configuring it. In particular, do not enable the switch until you have mapped the
VLANs (see
the necessary SSH keys (see
page 102).
Chapter 3 Managing the network access devices 93
"Managing network access devices using the SREM" on
"Mapping the VLANs using the SREM" on page
"Managing SSH keys using the SREM" on
Nortel Secure Network Access Switch 4050 User Guide
Figure 16 on
96) and exchanged