Using A Submenu Name As A Command Argument - Nortel Secure Network Access Switch 4050 User Manual

• To display the active menu:
— Ensure that the command line is blank.
— At the menu prompt, press the Tab key.

Using a submenu name as a command argument

To display the properties related to a specific submenu, you can include the
submenu name as an argument to the
up from the desired submenu information).
For example, to display system information at the Configuration menu prompt,
without descending into the System menu (
command:
>> Configuration# cur sys
>> Configuration#
System:
Management IP (MIP) address = 192.168.128.211
iSD Host 1:
Type of the iSD = master
IP address = 192.168.128.213
License =
IPSEC user sessions: 250
Secure Service Partitioning
PortalGuard
TPS: unlimited
SSL user sessions: 250
Default gateway address = 192.168.128.3
Ports = 1 : 2
Hardware platform = 3070
Host Routes:
No items configured
Host Interface 1:
IP address = 192.168.128.213
Network mask = 255.255.255.0
VLAN tag id = 0
Mode = failover
Primary port = 0
Interface Ports:
Host Port 1:
Autonegotiation = on
command (at a menu prompt one level
cur
/cfg/sys
cur sys
1
Nortel Secure Network Access Switch 4050 User Guide
Appendix A CLI reference 809
), use the following