Downloading Images Using The Srem - Nortel Secure Network Access Switch 4050 User Manual

748 Chapter 14 Maintaining and managing the system
4
Removing an inactive software image
To remove an inactive software images on the Nortel SNAS 4050 device to which
you are connected, perform the following steps:
1
2
3
4
The active image cannot be removed from the Nortel SNAS 4050 device. To
remove the active image, you must first select another available image to activate
(see

Downloading images using the SREM

Before you can perform a software upgrade, you must download the image file.
320818-A
When prompted, click Yes.
The Nortel SNAS 4050 reboots when you confirm the Activate command.
Note: When you activate a software upgrade on a Nortel SNAS 4050
device, all the Nortel SNAS 4050 devices in the cluster reboot. All active
sessions are lost.
Select the System > Boot > Image List tab.
The Image List screen appears (see
Select an inactive image from the table.
Inactive images have a Status of old or unpacked in the Image List.
Click Delete.
A confirmation dialog box appears.
When prompted, click Yes.
The image is removed from the Image List
"Activating a software image" on page
Figure 227 on page 744).
747).