Adding A Static Route - Nortel Secure Network Access Switch 4050 User Manual

518 Chapter 10 Configuring system settings
From the selected static route screen, complete the following tasks as necessary:
•
•

Adding a static route

To add a static routes, perform the following steps:
1
2
Figure 139
3
Table 101
Field
Destination Address
Netmask
Gateway
320818-A
"Adding a static route" on page 518
"Removing a static route" on page 519
Select the static route from the table.
Click Add.
The Add Route dialog box appears (see
Add Route
Enter the static route information in the applicable fields.
the Add Route fields.
Add Route fields
Note: When you add a static route to the system, host, or interface
configuration, the route is automatically assigned an index number.
There are separate sequences of index numbers for routes configured for
the cluster, for each host, and for each interface.
Figure
Description
Specifies the static route destination IP address.
Specifies the network mask to apply to the IP address.
Specifies the IP address on the core router.
139).
Table 101 describes