•
"Removing a host interface" on page 514
Adding a host interface
To create a host interface, perform the following steps:
1
Select the System > Hosts > host > Interfaces tab.
The Interfaces screen appears (see
2
Click Add.
The Add an Interface dialog box appears (see
Figure 134
Add an Interface
3
Enter the interface information in the applicable fields.
Add an Interface fields.
Table 99
Add an Interface fields
Field
Index
Ip Address
Chapter 10 Configuring system settings 509
Figure 133 on page
Description
An integer in the range 1 to 252 that uniquely identifies the
interface on the Nortel SNAS 4050.
Sets the network address for the interface. (For Interface 1,
the network address is the RIP.)
Nortel Secure Network Access Switch 4050 User Guide
508).
Figure
134).
Table 99
describes the