Disabling Or Reenabling An Ip Interface; Removing An Ip Interface; Displaying Ip Interface Information - Nortel 2360 Configuration Manual

The IP interface table flags the address assigned by a DHCP server with an asterisk ( * ). In the following example,
VLAN corpvlan received IP address 10.3.1.110 from a DHCP server.
WSS# show interface
* = From DHCP
VLAN Name Address
---- --------------- --------------- --------------- ------- ----- --------
4 corpvlan *10.3.1.110
Displaying DHCP client information
To display DHCP client information, type the following command:
WSS# show dhcp-client
Interface:
Configuration Status: Enabled
DHCP State:
Lease Allocation:
Lease Remaining:
IP Address:
Subnet Mask:
Default Gateway:
DHCP Server:
DNS Servers:
DNS Domain Name:

Disabling or reenabling an IP interface

IP interfaces are enabled by default. To administratively disable or reenable an IP interface, use the following command:
set interface vlan-id status {up | down}

Removing an IP interface

To remove an IP interface, use the following command:
clear interface vlan-id ip
Caution!
features that require the system IP address will not work correctly.

Displaying IP interface information

To display IP interface information, use the following command:
show interface [vlan-id]
Configuring and managing IP interfaces and services 125
Mask Enabled State RIB
255.255.255.0 YES
corpvlan(4)
IF_UP
65535 seconds
65532 seconds
10.3.1.110
255.255.255.0
10.3.1.1
10.3.1.4
10.3.1.29
mycorp.com
If you remove the IP interface that is being used as the system IP address,
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Up ipv4