Inserting Additional Sheets Into A Bound Book - Oce DFS10 Operator's Manual

Inserting additional sheets into a bound
book
Problem solving
Occasionally, you may wish to add sheets to a bound book.
The DFS10 enables you to do so. You cannot, however,
remove pages from a bound book.
To add sheets to a bound book, perform the following
procedure:
WARNING: Do not exceed the capacity of the cover spine
width of the bound book. To determine the maximum number
of sheets, refer to set size reference chart in chapter 7,
"Technical data".
WARNING: If you insert a new first or last sheet into the
bound book, the book may not bind properly.
1. Manually insert the sheet(s) into the bound book at the
appropriate spot(s).
• Tamp the sheet(s) into place as neatly as you can.
2. Open the Manual Feeder door.
3. Insert the bound book into the Manual Feeder.
NOTE: Follow the directions on the labels adjacent to the
Manual Feeder area of the DFS10 for the correct
positioning of the book.
4. Select (None) as the cover source from the Cover
Supply section on the Control Panel of the DFS10.
5. Press the Manual Start button on the Control Panel of the
DFS10.
6. Retrieve the book from the Output Tray of the DFS10 after
the binding process has completed.
Note: Refer to chapter 3, "Making the books", for
complete information about using the Manual Feeder.
59