Table of Contents
Advertisement
Confidential
Disassembly
The disassembly process is divided into the unit disassembly and the module disassembly.
First perform the unit disassembly; then proceed to the module disassembly after the
components have been disassembled into modules.
Disassembly of printer components beyond the exploded diagrams at the end of this manual
may result in damage to the printer and its functions.
<Check> and <Reassembly Point> are given in "Disassembly step" with
Make sure to follow the instructions given in these places when disassembly and
reassembly.
New wire bands are required when reassembly for wire bands cut during disassembly. See
page 6-29 and "Part name" in the disassembly steps for types and numbers of wire bands.
The numbers in the illustrations indicate the step numbers.
Component Configurations Overview
The EU-T532/T542 have two disassembly types for ASP (After Service Parts) replacement. The
one is "Unit disassembly" for disassembling the EU-T532/T542 into modules, the other one is
"Module Disassembly" for disassembling each module into small parts. The configurations
when performing those disassemblies are as follows:
Unit Disassembly
When performing the unit disassembly, the EU-T532/T542 are disassembled into the following
modules and parts. When you want to disassemble a corresponding item only, see the page and
the step numbers in brackets after part names.
Cover, UIB (p. 6-30)
Dust cap (p. 6-30)
COM, cover (p. 6-30)
Control circuit board module (p. 6-30 and p. 6-31: step 5)
Paper exit (p. 6-33: step 1)
Cut sheet presenter module (p. 6-30 to 34)
Printer module (p. 6-30, 31, and 33 to 35)
Plate, lower paper guide (p. 6-35: step 5)
Plate, paper guide holder (p. 6-35: step 5 and p.6-36: step 7)
Holding plate, printer (p. 6-30, 31 to 36)
Crescent ring (p. 6-37: step 9)
Holder, paper roll (p. 6-37)
Paper roll supply module (p. 6-30 to 37)
Rev. A
(p. 6-30 to 37)
EU-T532/T542 Technical Manual
and
Assembly and Disassembly 6-27
symbols.
Advertisement
Table of Contents
