Epson EU-T532 Technical Manual page 71

Confidential
Pre-assembly D
Reassembly
Part name
step
4 Cutter, motor assembly
C.B.(M2.3 × × × × 3)
Screw, switch
5 Cutter drive gear
sub-assembly
Plain washer (3 × × × × 0.5 × × × × 7) × 1
R.E. (2.5)
6-8 Assembly and Disassembly
Install the cutter, motor assembly to the cutter cover sub-assembly, and
× 1 secure it with the C.B.(M2.3 × × × × 3).
Install the microswitch to the cutter cover sub-assembly, and secure it with
the screw, switch.
screw, switch
C.B.(M2.3 × 3)
<Check>
Tightening torque: 245 to 294 mN•m {2.5 to 3.0 kg•cm} (C.B.(M2.3 × × × × 3))
Tightening torque: 108 to 147 mN•cm {1.1 to 1.5 kg•cm} (screw, switch)
Make sure to install the cutter, motor with the labeled side down.
Make sure that the cutter, motor is installed securely.
Make sure that the dowel on the microswitch fits securely in the mounting
hole on the cutter cover sub-assembly.
After lubricating the shaft on the cutter cover sub-assembly with G-36,
install the cutter drive gear sub-assembly and the plain washer
on the shaft; then secure them with an R.E.
× 1
plain washer
cutter drive gear
sub-assembly
G-36
Assembly procedure
microswitch
R.E.(2.5)
microswitch actuator
cutter motor
assembly
cutter cover
sub-assembly
mounting hole
cutter motor
Rev. A