Table of Contents
Advertisement
Confidential
Table 2-6 Print Density Selection
Level
Print Density
1
Slightly light
2
3
Slightly dark
4
Table 2-7 Operation Mode Selection
Operation mode
Hexadecimal dump
Normal
Notes:
・Changes in DIP switch settings (excluding switches 2-7 and 2-8 interface reset signals) are recognized only
when the printer power is turned on or when the printer is reset by using the interface.
・If you turn on DIP SWs 2-7 and 2-8 while the printer power is turned on, the printer may be reset, depending on
the signal state. DIP switches should not be changed while the printer power is on.
Memory Switches
Other settings except DIP switches 1 and 2 are set by the memory switches. (The settings are
changed with a GS (E command, and also can be changed by using the MEMSW.exe included
with an EPSON Advanced Windows Driver.) The settings of the memory switches are as
follows:
Table 2-8 Memory Switch 1
SW No.
Function
1
Reserved
2
3
BUSY condition
4
Receive error
5
Auto line feed
6 to 8
Reserved
(*1): Effective only in the serial interface model.
(*2): Effective only in the parallel interface model.
Table 2-9Memory Switches 2 to 6
SW No.
Function
1 to 8
Reserved
Rev. A
Switch No.3
OFF
Normal
OFF
Dark
Switch No.5
ON
OFF
ON (1)
Receive buffer full
Ignored
Always enabled
ON (1)
Switch No.4
ON
ON
OFF
ON
OFF
ON
OFF (0)
Fixed to OFF
Receive buffer full
or offline
Prints "?"
Always disabled
Fixed to OFF
OFF (0)
Fixed to OFF
EU-T532/T542 Technical Manual
Default setting
OFF(0)
ON(1)
OFF(0) (*1)
OFF(0) (*2)
OFF(0)
Default setting
OFF(0)
Operation Principles 2-21
Advertisement
Table of Contents
