Epson EU-T532 Technical Manual page 34

Confidential
Table 2-12 Memory Switch 8
SW No. Function
1 to 2
Print control mode
3 Backward paper
feeding
4 Autocutter
installation
5 Specific offline
operation
6 Backward paper
feeding amount
7 Test print when the
paper is loaded
8 Black mark position
(*1): Do not set SW 3 to ON in the following condition:
• The partial cutter is used when the cut sheet presenter module is not used.
When backward paper feeding is enabled, the following process is executed.
• After cutting the paper with a GS V command, backward paper feeding is executed. (When the Black
mark sensor is disabled.)
• The print starting position adjustment with a GS (F command can be set to the backward direction
relative to the cutting position. In this case, the maximum backward correction value is 14 mm {0.55"}
(112 step × 0.125 mm {0.005"} per step).
(*2): Specific offline means the following states.
• Error state except an automatic recovery error state
• Platen open
• Cut sheet presenter module or cover open
• Paper empty
If this switch is turned on, the printer clears the receive buffer when the offline status shown above occurs. Then
the printer executes any real-time command (DLE ENQ, DLE EOT) if it is there, and discards all other data.
When the receive buffer is cleared, if this switch is turned on, three bytes of data, 37H, 24H, and 00H, are
transmitted.
Table 2-13 Print Control Mode Selection
Default for the print
control mode
Non-divided energizing
mode
Two-part energizing
mode
Four-part energizing
mode
Rev. A
ON (1)
Refer to 2-13
Enabled Disabled
Not installed Installed
Discards receive Keeps receive data
data
88 steps 108 steps
Disabled
Enabled
Initializes the BM Not initialize the BM
position position
SW 1
OFF
ON
Either ON or OFF
EU-T532/T542 Technical Manual
OFF (0)
Default setting
OFF(0)
OFF(0) (*1)
OFF(0)
OFF(0) (*2)
OFF(0)
SW 2
OFF
OFF
ON
Operation Principles 2-23