Epson EU-T532 Technical Manual page 105

Confidential
Disassembly
step Disassembly part name
12 Paper roll tension unit
13 Paper, NE detector
assembly
Screw, paper NE
detector
14 Paper NE harness
assembly
Wire band (SKB-85) × 1
15
16 Photo interrupter
Plate, paper NE
detector
C.P (P2)
plate, paper NE detector
photo interrupter
plate spring, earth
conductions B
6-42 Assembly and Disassembly
× 1
Remove the paper roll tension unit from the shaft, paper roll.
<Reassembly Point>
1. Make sure not to bend the plate spring, earth conductions B when attaching
the paper roll tension unit to the shaft, paper roll.
2. Pass the paper NE harness assembly throught the rectangle hole on the
frame, main, and secure it at the position of 280 ± 5 mm with a wire band.
3. Cut the extra part of the wire band.
Remove the screw, paper NE detector; then paper NE detector assembly
× 1
attached to the rear side of the paper roll tension unit will come off.)
× 1
<Reassembly Point>
During reassembly, secure the paper NE detector assembly at the same
position as the position before disassembly.
Disconnect the paper NE harness assembly from the photo interrupter.
× 1
Cut the wire band securing the paper NE harness assembly to the plate,
paper NE detector.
<Reassembly Point>
When binding the paper NE harness assembly with a wire band, be sure that
the wire band is extended 1.2 mm or less from the rear side of the plate, paper
NE detector.
× 1
Remove the C.P (P2) securing the plate, paper NE detector and the photo
interrupter to remove the photo interrupter.
× 1
× 1
<Reassembly Point>
Tightening torque: 392 mN•m {4 kg•cm}
14
16
13
Disassembly procedure
15
12
paper roll tension unit
shaft, paper roll
rectangle
hole
Rev. A