Cut Sheet Presenter Module - Epson EU-T532 Technical Manual

Confidential

Cut Sheet Presenter Module

Opening/closing the cut sheet presenter module (See Figure 3-2.)
1. Remove the white screw on the opposite side of the mounting dowels.
2. Put your fingers on/around the seal, paper exit guides (green stickers) on the upper
frame, cut sheet presenter unit and on the paper exit; then pull the cut sheet presenter
module in the direction of arrow E to slide it in direction E.
Note:
Be careful with your hand, as the module is pulled in the direction of arrow F with spring.
3. Pull the module further until the mounting dowels on the module are disengaged; then the
module is turned downward and opened.
4. To put the module back to the previous position, lift up the bottom of the paper exit. At this
time, make sure that the mounting dowels (both on the right and left sides) are securely
engaged with the mounting parts on the module.
Opening/closing the upper frame, cut sheet presenter unit (See Figure 3-2.)
1. Turn the lever, clamp in the direction of arrow G to open the unit. You can operate either
lever on the right or the left.
2. To close the unit, turn the lever, clamp in the direction of arrow H. At this time, make sure
that the lever, clamp is properly engaged with the shaft, clamp lever.
Note:
Do not lift the upper paper guide when the upper frame, cut sheet presenter unit is
closed.
holder, paper roll
(Inside: shaft, paper roll)
plate, fixed
paper roll hold unit
lever, platen
Rev. A
A
B
mounting dowels
Figure 3-2 Opening/closing units and module
EU-T532/T542 Technical Manual
lever, clamp
upper paper guide
H
D
G
C
F
cut sheet presenter module
E
upper frame, cut sheet
presenter unit
seal, paper exit guide
paper exit
white screw side
Handling 3-5