Table of Contents
Advertisement
Confidential
Table 2-10 Memory Switch 7
SW No.
Function
1
Reserved
2
Setting for the
secondary paper
3
near-end position
4
Operation after
cutting
5
Paper initializing
operation when the
power is turned on
6 to 8
Reserved
(*1): •Effective only for the model type with the paper roll supply module
•This setting lets the printer tell the paper nearend by sending the secondary paper nearend status when the
specified length of paper is fed after the primary paper nearend sensor in the paper roll supply module
detects the paper nearend.
(*2): Effective only when using with the cut sheet presenter module.
Table 2-11 Setting for Paper Nearend Detecting Position
Paper length
(for the time between detecting the
primary paper nearend with the
nearend sensor and sending the status
of the secondary paper near-end)
Approximately 5 m {196.85"}
Approximately 10 m {393.70"}
Approximately 20 m {787.40"}
Approximately 30 m {1181.10"}
Definition of the primary paper nearend and the secondary paper nearend:
• The primary paper nearend is defined as when the paper nearend sensor in the paper roll supply module detects
the paper roll nearend.
• The secondary paper nearend is defined as when the paper is fed for the specific length after the primary paper
nearend is detected.
When the primary and the secondary paper nearends are detected, the status from the printer changes. However,
printer controls, such as the printing stop are not affected.
2-22 Operation Principles
ON (1)
Fixed to OFF
Refer to Table 2-11
Complete ejection
Clamp
Paper edge is
Paper edge is
always cut.
detected.
Fixed to OFF
Memory SW No.7-2
OFF
ON
OFF
ON
OFF (0)
Default setting
OFF(0)
OFF(0) (*1)
OFF(0) (*2)
OFF(0)
Memory SW No.7-3
OFF
OFF
ON
ON
Rev. A
Advertisement
Table of Contents
