Epson EU-T532 Technical Manual page 107

Confidential
Disassembly
step Disassembly part name
5
6 Wire band (SKB-1.5M)× 1
7 Cable, presenter
module
6-44 Assembly and Disassembly
Disconnect all connectors from the presenter module circuit board assembly.
Cut the wire band securing the cable, presenter module to the lower frame
unit.
After disconnecting the cable, presenter module from the presenter module
× 1
circuit board assembly, pull it out from the rectangle hole on the lower
frame unit.
<Reassembly Point>
1. Fold the cable at right angle at the position about 10 mm away from the
connector for the presenter module circuit board assembly.
2. Fold the cable at 45° at the position folded in step 1.
(Fold the cable so that it faces the rectangle hole on the lower frame
unit.)
3. Pass the cable throught the rectangle hole on the lower frame unit.
1
about 10 mm {0.39"}
90°
2
front side
7
5
Disassembly procedure
rectangle hole
3
45°
rear side
6
lower frame unit
cable
presenter module
circuit board
assembly
Rev. A