Loading/Removing Paper; Loading Paper - Epson EU-T532 Technical Manual

Confidential

Loading/Removing Paper

Loading Paper

See the sticker on the paper roll hold unit for the paper loading.
paper roll hold unit
plate, fixed
Note:
Use only the paper specified in the EU-T532 and the EU-T542 specifications issued by Seiko Epson
Corporation.
Loading paper for the paper roll supply module
Follow the steps below to load the paper for the paper roll supply module.
1. Lift the plate, fixed upward to release the lock with the shaft, paper roll.
2. Open the paper roll hold unit.
3. Attach a holder, paper roll which meets the inside diameter of the paper core to the shaft,
paper roll; then secure it with a C-ring.
Note:
At the default setting, the holder, paper roll A (for the inner diameter of the paper core is 25.4 mm
{1"}) is attached to the paper roll supply module. Since two holders, the holder, paper roll B (if the
inner diameter of the paper core is 50.8 mm {2"}), and the holder, paper roll C (if the inner
diameter of the paper core is 76.2 mm {3"}), are also packed in the box, use the appropriate holder,
paper roll that meets your paper core size.
4. Load the paper roll to the holder, paper roll with the printing surface of the paper facing
upwards.
5. Close the paper roll hold unit to secure the paper roll. At this time, make sure that the
plate, fixed is securely engaged with the shaft, paper roll.
3-6 Handling
Figure 3-3 Paper loading display on sticker
Rev. A