Epson EU-T532 Technical Manual page 87

Confidential
Main Assembly H
Reassembly
Part name
step
1 Cutter unit
C.B.S-tite (M3 × × × × 5)
6-24 Assembly and Disassembly
Installation of the Cutter unit
Install the cutter unit to the frame assembly and secure it with screws,
× 2
while the lead wire, paper cutter is passed through the hook on the frame
assembly.
lead wire, paper cutter
platen
<Check>
Tightening torque: 686 to 882 mN•m {7 to 9 kg•cm}
Make sure that the lead wire, paper cutter is passed through the hook on
the frame assembly properly as shown above.
Make sure that the lead wire, paper cutter is not caught between any
places when securing the cutter unit.
Install the cutter unit in the platen-up state.
Lubricate the point where the fixed blade, H of the cutter unit contacts
the cutter frame with G-15.
cutter unit
Assembly procedure
G-15
C.B.S-tite (M3 × 5)
cutter unit
frame assembly
G-15
Rev. A