Ep, Developer, Toner Add Gearbox Removal - Lexmark CX825 Service Manual

9
Remove the four screws from the fan, and then remove the duct.

EP, developer, toner add gearbox removal

1
Remove the toner cartridges, developer and PC unit combos, and transfer belt.
2
Remove the rear lower cover. See
3
Remove the rear upper cover. See
4
Remove the column outer cover. See
5
Remove the right cover. See
6
Remove the controller board cover. See
7
Remove the left upper cover. See
8
Remove the rear left cover. See
9
Remove the controller board cage. See
10
Remove the LVPS cage. See
11
Remove the main fan duct. See
12
Remove the seven screws (A), and then release the cables from the cable guides.
Warning—Potential Damage: The flat cable is fragile. Be careful when detaching the cable from the
gearbox.
A
"Rear lower cover removal" on page
"Rear upper cover removal" on page
"Column outer cover removal" on page
"Right cover removal" on page
"Controller board cover removal" on page
"Left upper cover removal" on page
"Rear left cover removal" on page
"Controller board cage removal" on page
"LVPS cage removal" on page
"Main fan duct removal" on page
Repair information
689
672.
672.
629.
629.
605.
673.
684.
681.
688.
7564
671.