Multiposition Staple, Hole Punch Finisher Symptoms - Lexmark CX825 Service Manual

Action
Step 10
Enable WiFi direct in the printer.
Does the problem remain?
Step 11
Verify that the NFC tap sticker is in the proper place on the control
panel.
Is the NFC tap sticker properly located on the control panel?
Step 12
Using a template, reposition the tap sticker.
Note: The sticker should be placed over the NFC antenna on the
mobile solutions module.
Does the problem remain?
Step 13
Check if the mobile solutions module is properly installed on the
control panel assembly.
Is the mobile solutions module properly installed?
Step 14
Reinstall the mobile solutions module on the control panel
assembly.
Does the problem remain?
Step 15
Install a new NFC card.
Does the problem remain?
Multiposition staple, hole punch finisher symptoms
MSHPF symptoms
Symptom
A persistent Close door K message appears.
The MSHPF is not detected.
Hole punch quality is poor.
The MSHPF front door is not detected.
Action
See "HPT door undetected service check" on
page 535.
See "Multiposition staple, hole punch finisher
undetected service check" on page
See "Hole punch quality service check" on
page 537.
See "MSHPF front door undetected service
check" on page 540.
Diagnostic information
534
Yes No
Go to step 11. The problem is
solved.
Go to step 13. Go to step 12.
Go to step 13. The problem is
solved.
Go to step 15. Go to step 14.
Go to step 15. The problem is
solved.
Contact the next The problem is
level of support. solved.
536.
7564