Main Fan Duct Removal - Lexmark CX825 Service Manual

7
Remove the controller board cage. See
8
Remove the right cover. See
9
Cut the cable tie (A), and then disconnect the cable from the motor (B).
10
Remove the three screws (C), and then remove the motor gearbox.
Installation note: Make sure to replace the cable tie, and reinstall the motor cover.

Main fan duct removal

1
Remove the fuser. See
2
Remove the controller board cover. See
3
Remove the rear lower cover. See
4
Remove the rear upper cover. See
5
Remove the left upper cover. See
6
Remove the rear left cover. See
7
Remove the controller board cage. See
8
Open door B, remove the screw (A) behind the duct, and then pull the fan duct.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
"Controller board cage removal" on page
"Right cover removal" on page
C
B
"Fuser removal" on page
"Controller board cover removal" on page
"Rear lower cover removal" on page
"Rear upper cover removal" on page
"Left upper cover removal" on page
"Rear left cover removal" on page
"Controller board cage removal" on page
Repair information
629.
A
606.
605.
673.
688
684.
671.
672.
672.
684.
7564