Lexmark CX825 Service Manual page 309

Action
Step 7
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Sensor tests > Finisher
b
Find the sensor (Diverter).
Does the sensor status change while toggling the sensor?
Step 8
Reseat the sensor cable, and then check the sensor for
misalignment and damage.
Is the sensor properly installed and free of damage?
Step 9
Reinstall or replace the sensor. See
removal" on page 975.
Does the problem remain?
Step 10
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Motor tests > Finisher > Staging
diverter
b
Touch Start.
Does the motor run?
Step 11
Reseat the motor cable, and then check the motor for misalignment
and damage.
Is the motor properly installed and free of damage?
Step 12
Reinstall or replace the motor.
Does the problem remain?
Step 13
Check the staging diverter and its fingers and spring for
misalignment and damage.
Is the diverter properly installed and free of damage?
Step 14
Turn the staging diverter gear and check if the position of the
diverter changes.
Does the diverter change position?
"Sensor (staging diverter)
Diagnostic information
309
Yes No
Go to step 10. Go to step 8.
Go to step 10. Go to step 9.
Go to step 10. The problem is
solved.
Go to step 13. Go to step 11.
Go to step 13. Go to step 12.
Go to step 13. The problem is
solved.
Go to step 16. Go to step 14.
Go to step 16. Go to step 15.
7564