Sensor (Mshpf Staple Unit Position) Removal - Lexmark CX825 Service Manual

8
Turn the gear counterclockwise until the carriage is released.
9
Remove the staple unit from the carriage. See

Sensor (MSHPF staple unit position) removal

Note: Make sure that the staple carriage is in the service position. Before turning off the printer, enter the
Diagnostics menu, and then navigate to Output device diagnostics > Motor tests > Finisher > Staple unit,
service position.
1
Remove the MSHPF controller board cover. See
2
Remove the MSHPF right cover. See
3
Remove the MSHPF bottom right cover. See
4
Remove the MSHPF rear cover. See
"MSHPF staple unit removal" on page
"MSHPF controller board cover removal" on page
"MSHPF right cover removal" on page
"MSHPF bottom right cover removal" on page
"MSHPF rear cover removal" on page
Repair information
947
955.
922.
923.
931.
7564
930.