Stack Height Assembly Removal - Lexmark CX825 Service Manual

Installation note: Route the sensor cable as shown. The segment of the cable (A) routes through the cable
guide and then directly to the sensor. The cable guide should wrap around the shrink tube (B) of the cable.

Stack height assembly removal

1
Remove the multiposition stapler assembly. See
2
Disconnect the two cables (A), remove the two screws (B), and then cut the cable ties (C).
Installation warning: Replace the cable ties, or the cables may interfere with moving parts.
B
Repair information
"Multiposition stapler assembly removal" on page
1135
7564
A
1114.