Motor (Mid-Transport) Removal - Lexmark CX825 Service Manual

Motor (mid-transport) removal

1
Remove the MSHPF controller board cover. See
2
Remove the MSHPF right cover. See
3
Remove the MSHPF bottom right cover. See
4
Remove the MSHPF rear cover. See
5
Remove the MSHPF standard bin exit belt. See
6
Remove the two screws (C), and then pull the bracket.
7
Cut the cable tie (D), disconnect the cable (E), and then remove the cap (F).
Installation warning: Replace the cable tie, or the cable may interfere with moving parts.
"MSHPF controller board cover removal" on page
"MSHPF right cover removal" on page
"MSHPF bottom right cover removal" on page
"MSHPF rear cover removal" on page
"MSHPF standard bin exit belt removal" on page
C
Repair information
1001
922.
923.
931.
996.
7564
930.