Lexmark CX825 Service Manual page 287

Action
Step 8
a
Check the staple finisher aligner paddle for any wear or
damage, and replace if necessary. See
paddle and upper paper guide removal" on page
b
Manually turn the aligner paddle to check it for proper
operation.
c
Check the aligner paddle for proper installation.
Does the problem remain?
Step 9
Reseat all cable connectors in the staple finisher controller board,
and then reset the printer.
Does the problem remain?
Step 10
Replace the controller board. See
board removal" on page
Does the problem remain?
Staple finisher bin clamp jam service check
Action
Step 1
a
Clear the staple finisher bin.
b
Clear the paper path of any obstruction.
c
Reset the printer.
Does the problem remain?
Step 2
a
Enter the Diagnostics menu, and then navigate to:
Output device diagnostics > Motor tests
b
Find the motor (Bin clamp), and then touch Start.
Does the motor run?
Step 3
a
Check the motor (staple finisher bin clamp) for damage, and
replace if necessary. See
removal" on page
b
Check the motor for proper installation.
c
Reseat the motor connector on both ends.
Does the problem remain?
"Staple finisher aligner
"Staple finisher controller
790.
"Motor (staple finisher bin clamp)
854.
Diagnostic information
Yes
Go to step 9.
838.
Go to step 10.
Contact the next
level of support.
Yes
Go to step 2.
Go to step 4.
Go to step 4.
287
7564
No
The problem is
solved.
The problem is
solved.
The problem is
solved.
No
The problem is
solved.
Go to step 3.
The problem is
solved.