f
Rotate the gear (D) until the carriage is positioned as shown.
g
Install the cable support, and then connect the cable to the interface board.
Note: Make sure that the cable is properly routed.
Stapler bin assembly removal
1
Remove the multiposition stapler assembly. See
2
Remove the MSHPF compiler tray. See
3
Remove the stapler bin elevator drive. See
D
"Multiposition stapler assembly removal" on page
"MSHPF compiler tray removal" on page
"Stapler bin elevator drive removal" on page
Repair information
1176
7564
1114.
1153.
1163.