Table of Contents
Advertisement
12 Using the Scan Service
Configuration of Network Scanning (Job Template Scanning)
Preparations
The following environment is required to use the job template scanning function on the
machine.
Note
Installation Overview
12
This section describes the configuration procedure to use the job template scanning
function on the machine.
The following is the procedure to use the job template scanning.
Enabling Port and Setting TCP/IP
In order to use Network Scanning feature on the machine, enable the ports and set the
IP address. The procedure for setting the machine is as follows.
Note
For information on how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.63).
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
Note
3) Select [System Settings].
2
Enable the SNMP port.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [SNMP] and then select [Change Settings].
5) Select [Port Status] and select [Change Settings].
6) Select [Enabled] then select [Save].
116
• To use SMB forwarding, your computer must have one of the following operating systems
that supports folder sharing.
- Microsoft Windows NT 4.0
- Microsoft Windows 2000
- Microsoft Windows Server 2003
- Microsoft Windows XP
Enabling port and setting TCP/IP
Enable the SNMP port, Internet Services (HTTP) port, and SMB or FTP client port,
and then set an IP address on the machine.
Configuring the SNMP port
Configure the transport protocol for the SNMP port using CentreWare Internet
Services.
• The configuration can also be performed using CentreWare Internet Services.
[Keyboard], and select [Confirm].
• The default user ID is "11111". When using the Authentication feature, a passcode is
required. The default passcode is "x-admin".
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
