Epc Hard Drive - Xerox DocuColor 12/DCCS50 Service Manual

REP 20.2 EPC Hard Drive
Parts List on PL 20.1
Removal
Use the ESD Kit and the established ESD procedures when replacing the EPC PWB. The EPC
PWB can be damaged by electrostatic discharge.
1. For DCCS50:
• Switch Off the power. Wait 30 seconds, then unplug the power cord. Disconnect the
IDFE DDI Cables.
For DC12 with attached Fiery or Splash DFE:
• Perform the correct power down procedure. Disconnect the DFE DDI cables.
For DC12 without an attached DFE:
• Switch off the power and disconnect the power cord.
2. Access the EPC Hard Drive (Figure
1
Loosen the screws (6)
Figure 1 Accessing the EPC Hard Drive
3. Remove the EPC Hard Drive (Figure
Electronic Pre-Collation (EPC)
REP 20.2
CAUTION
1).
2
Lower the Cover
2).
3
Remove the EPC Hard Drive
Figure 2 Removing the EPC Hard Drive.
Replacement
1. Reinstall the parts in the reverse order of disassembly.
2. Initialize the EPC (GP 1).
1/05
8e-10
manuals4you.com manuals4you.com
1
Disconnect the
Connectors (2)
2
Remove the
screws (4)
Reissue
DocuColor 12/DCCS50