Ricoh D065 Service Manual page 568

Leading Edge:
022
After Punch
Trailing Edge:
023
After Punch
Off Timing: After
024
Punch
2940* Reface Mode
Determines if a blade bend prevention pattern is made when the ID sensor
pattern is made. This setting controls the pattern count. DFU
[0 to 100/0/1]
Increase the setting if the rotation of the drum is not smooth, that is, when drum
rotation is making noise.
2950 Vh Pattern Create
001 Exposure Level
002 Offset Light Amount
Process Interval Additional Time. DFU
2960
[0 to 7/0/1 sec]
Developer Adjust Mode DFU
2961
2962 Automatic Adjustment of Drum Conditions
SM Appendix
[–30 to +30/20/1 mm]
Adjusts the area where transfer current is applied for the
leading edge during copying with punch.
[0 to +20/0/1 mm]
Adjusts the area where transfer current is applied for the
trailing edge during copying with punch.
[0 to +20/0/1 mm]
Adjusts the transfer current OFF timing for copying with
punch.
[–30 to +30/-16/1 mm]
Vh Pattern Creation Setting DFU
[0 to 15/7/1]
[-100 to 0/-45/1]
4-35
Service Program Mode Tables
D062/D063/D065/D066