Service Call Conditions
Tray overload detected when
the tray is set.
The lower limit sensor of the
LCT does not detect the
lower limit within 10 s.
Tray 2 lift malfunction
The lift sensor is not
activated within 10 s after
the tray lift motor starts lifting
the bottom plate.
502
B
When the tray lowers, the
tray lift sensor does not go
off within 1.5 s.
Tray overload detected when
the tray is set.
D062/D063/D065/D066
Note
At first, the machine displays a
message asking the operator to
reset the tray.
This SC will not display until the
operator has pulled the tray out and
pushed it in 3 times.
If the operator turns the machine
off/on before the 3rd opening and
closing of the tray, the 3-count is
reset.
Tray lift motor defective or
disconnected
Paper or other obstacle trapped
between tray and motor
Pick-up solenoid disconnected or
blocked by an obstacle
Too much paper loaded in tray
Note
At first, the machine displays a
message asking the operator to
reset the tray.
This SC will not display until the
operator has pulled the tray out and
pushed it in 3 times.
If the operator turns the machine
off/on before the 3rd opening and
closing of the tray, the 3-count is
reset.
3-22
SM Appendix