Ricoh D065 Service Manual page 506

Power Loss During
9
Data Conversion
Data Read Command
10
Error
HDD startup error at power on
HDD is connected but a driver
error is detected.
860 B
The driver does not respond
with the status of the HDD
within 30 s.
HDD Error 2: HDD Startup
The hard disks were detected at power on, but the disks were not detected
within 30s after recovery from the energy conservation mode.
861 B
Cable between the hard disks and controller board disconnected or
loose
Hard disk power connector loose
One of the hard disks is defective
Controller defective
Bad sector overflow
862 D
There more 100 bad sectors in
image storage area of the HDD.
SM Appendix
Initialize HDD with SP5832-1
Note: After installation, a new HDD should be
formatted with SP5832-1
Data conversion stopped before NVRAM/HDD
data was converted.
Format HDD with SP5832-1
More than two illegal DMAC communications
were returned.
HDD defective
Format HDD with SP5832-1
Replace HDD
HDD is not initialized
Level data is corrupted
HDD is defective
HDD defective
Format HDD with SP4911-2
3-61
Service Call Conditions
GW
D062/D063/D065/D066