Ricoh D065 Service Manual page 468

Tray 3 lift malfunction
The lift sensor is not
activated within 10 s after
the tray lift motor starts lifting
the bottom plate.
503 B
When the tray lowers, the
tray lift sensor does not go
off within 1.5 s.
Tray overload detected when
the tray is set.
Tray 4 lift malfunction
The lift sensor is not
activated within 10 s after
the tray lift motor starts lifting
the bottom plate.
504 B
When the tray lowers, the
tray lift sensor does not go
off within 1.5 s.
Tray overload detected when
the tray is set.
SM Appendix
Service Call Conditions
Tray lift motor defective or
disconnected
Paper or other obstacle trapped
between tray and motor
Pick-up solenoid disconnected or
blocked by an obstacle
Too much paper loaded in tray
Note
At first, the machine displays a
message asking the operator to
reset the tray.
This SC will not display until the
operator has pulled the tray out and
pushed it in 3 times.
If the operator turns the machine
off/on before the 3rd opening and
closing of the tray, the 3-count is
reset.
Tray lift motor defective or
disconnected
Paper or other obstacle trapped
between tray and motor
Pick-up solenoid disconnected or
blocked by an obstacle
Too much paper loaded in tray
Note
At first, the machine displays a
message asking the operator to
reset the tray.
This SC will not display until the
operator has pulled the tray out and
3-23 D062/D063/D065/D066