Ricoh D065 Service Manual page 127

Use the two small tapping screws that are supplied, and not the machine
screws removed from the finisher guide plate.
6. Release the lock lever [D] (
7. Attach the pad [E]. (This pad is provided with the finisher.)
8. Slowly push the finisher against the side of the machine until the brackets [F] go into
the slots.
Move the finisher carefully, or you will bend the entrance guide plates.
9. Attach the lock lever [D] (
10. Connect the connector [G] to the copier.
Check the duct [A] on the left side of the machine.
Make sure that the sponge does not prevent air flow through this duct.
SM
x 1).
x 1).
2-79
Cover Interposer Tray (B704)
D062/D063/D065/D066