Ricoh D065 Service Manual page 706

Rev. 10/01/2009
Stamp Unit
Sets the stamp unit to set or unset.
6801
[0 to 1/1]
0: set, 1: unset
Extra Staples
More than the standard number of corner staples can be loaded.
This SP recognizes the maximum number of staples (This Setting + Standard
Number).
If the number of the maximum for staples is increased, and the mechanical
6830
warranty of the unit can be guaranteed, then the setting can take effect
without changing the controller software.
However, assurance that mechanical performance can be guaranteed is
required before changing the setting to increase the staple load for more
than the maximum in the feed / exit specifications. Raising this setting
without quality assurance could damage the machine.
0 to 50 (Initial: 0)
001
[0 to 50 /0/1]
0 to 50 (Initial: 0)
002
[0 to 50 /0/1]
⇒
Punch Function Enabled (Z-Fold)
6890
Switch Z-Folding OFF and ON. Deault: 0 (OFF)
0: No, 1: Yes
ADF Bottom Plate Setting
6900*
Sets the timing for raising and lowering the bottom plate of the ADF.
[0 to 1/1]
0: Original set, 1: Copy start
6910 Intermittent Shading
001 ON/OFF
SM Appendix
Select ON or OFF of the intermittent shading in running
the copy app.
0: OFF (do shading every time) / 1: ON
4-173
Service Program Mode Tables
D062/D063/D065/D066