Ricoh D065 Service Manual page 546

[600 to 1500/650/10 V]
Use this if there is a copy quality problem when making OHP's.
006 Total Bias Grid Current: Photo Mode Total
Adjusts the voltage applied to the grid plate when Photo mode is selected.
[1400 to 2800/1500/10
2101* Printing Erase Margin
These settings adjust the erase margin for the leading, trailing, left, and right
edges.
001 Leading Edge
002 Trailing Edge
003 Left Edge
004 Right Edge
LD Power Adjustment DFU
2103
Note: This is an SSP mode. To enter SSP mode, push [Reset], enter "107", then
hold down [Clear] for at least 3 sec. When you see "Copy SP" on the touch
panel, press and hold down [#] then touch "Copy SP".
LD0 Power
001
Adjustment
LD1 Power
002
Adjustment
LD2 Power
003
Adjustment
LD3 Power
004
Adjustment
005 LD0 Adjustment
SM Appendix
A]
[0 to 9/2.5/0.1 mm], Specification: 3±2 mm
[0 to 9/2/0.1 mm], Specification: 3±2 mm
[0 to 9/2/0.1 mm], Specification: 2±1.5 mm
These SP codes allow adjustment of the laser intensity for
each of the four channels.
[-64 to +64/0/1]
These SP codes allow adjustment of the start/end timing of
4-13
Service Program Mode Tables
D062/D063/D065/D066