Ricoh D065 Service Manual page 788

099 Status Lamp (Red)
100 PTL
200 Scanner Fanmotor
202 Scanner Lamp
203 Scanner Motor
4.2.3 ADF INPUT CHECK: SP6007
1. Open SP mode SP6007.
2. Select the SP number that corresponds to the component you wish to check. (Refer to
the table below.)
3. Press On then press Off to test the selected item. You cannot exit and close this
display until you click Off to switch off the output check currently executing.
6007 ADF Input Check
Description
0
001 Original Length Sensor 1 (B5)
002 Original Length Sensor 2 (A4)
003 Original Length Sensor 3 (LG)
004 Original Width Sensor 1
005 Original Width Sensor 2
006 Original Width Sensor 3
007 Original Width Sensor 4
008 Original Width Sensor 5
009 Original Set Sensor
010 Separation Sensor
SM Appendix
Reading
1
No paper
No paper
No paper
No paper
No paper
No paper
No paper
No paper
No paper
No paper
4-255
Input/Output Check
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
D062/D063/D065/D066